Compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Nofence has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Contains FCC ID: XPYUBX20VA01, ISED ID: 8595A-UBX20VA01 with an integrated antenna.

This product emits radio frequency energy, but the radiated output power of this device is far below the FCC radio frequency exposure limits.

This equipment complies with FCC RF radiation exposure limits for an uncontrolled environment. Nevertheless, the device should be used in such a manner that the potential for human contact with the antenna during normal operation is minimized.

In order to comply with FCC RF Exposure requirements, this device must be installed to provide at least 20 cm separation from the human body at all times.

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS. Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.”

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes:
1. L’appareil ne doit pas produire de brouillage ;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

“In order to comply with ISED RF Exposure requirements, this device must be installed to provide at least 20 cm separation from the human body at all times.

“Afin de se conformer aux exigences d’exposition RF ISED, cet appareil doit être installé pour fournir au moins 20 cm de séparation du corps humain en tout temps.

CAN ICES-3 (B)/NMB-3(B)

We, Nofence AS, declare under our sole responsibility that the products Cattle Collar version 25 and Sheep/Goat Collar version 25, to which this declaration relates, are in conformity with the following EU Directives:
Radio Equipment Directive (2014/53/EU).
RoHS2 Directive 2011/65/EU and RoHS3 2015/863/EU

The product is in conformity with the following standards and/or other normative documents:

Essential requirements under the RED Directive
Article 3.1(a): Health and Safety:

• EN IEC 62368-1:2020 + A11:2020

• EN IEC 60335-2-76:2021+A11:2021

• EN 60335-1:2012+A11:2014+A13:2017+A1:2019+A14:2019+A2:2019

• EN 50401:2017

Article 3.1(b): EMC

• EN 301 489-01:V2.2.3

• EN 301 489-17:V3.2.4

• EN 301 489-19:V2.2.0

• EN 301 489-52:V1.2.0

• EN 55032:2015 + AC:2016 + A11:2020

Article 3.2: Radio Spectrum:

• ETSI EN 300 328 v2.2.2 (2019-07)

• Parts of ETSI EN 303 413V1.2.1 (2021-04)

• Parts of ETSI EN 301 511V12.5.1 (2017-03)

• Parts of ETSI EN 301 908-1 V13.1.1 (2019-11)

Article 3.3: Cyber-Security:

• (d) EN 18031-1:2024

• (e) EN 18031-2:2024

RoHS Directive:

• EN IEC 63000:2018

Function: Frequency bands (maximum power transmitted)

• BLE: 2402-2480 MHz (<10 dBm)

• 2G: 900/1800 MHz (< 30dBm)

• LTE-M: 699-1990 MHz (<23 dBm)